Connect to this WiFi, using your mobile or PC or whatever.Initially the pedal will launch a WiFi Access Point (AP), SSID is "SparkBox" by default.Holding BUTTON 1 during boot will switch the pedal to WiFi mode. On the first run your current set of hardware presets will be saved to the bank 000.If you stop scrolling for a few seconds, the selected bank will be uploaded to the amp. Long pressing BUTTON 2 or BUTTON 4 invokes Bank Select menu, continue using BUTTONS 2 and 4 to decrease/increase bank number.Holding BUTTON 1 during boot will switch the pedal to WiFi mode.Bypass mode, invoked by long pressing BUTTONS 3 and 4 simultaneously, allows adjusting effect levels to match your raw pickup output.Now with remote guitar TUNER display! Long press BUTTONS 1 and 2 simultaneously, or turn it ON from the app or on the amp.Long press BUTTON 3 to adjust current effect parameters: use BUTTONS 2 and 4 to decrement/increment, BUTTON 1 to cycle thru parameters and long press BUTTON 3 to save your edits back to the amp.Long press (more than 1s) BUTTON 1 to switch between Effect mode and Preset mode.Stand-by mode added to reduce power when disconnected - light or deep ESP32 sleep mode will be configured automatically depending on GPIOs of the buttons and logical levels choosen in your build.Also tested on WEMOS LOLIN32 Lite with battery support. Inter-operable with both conventional and Heltec ESP32 modules.Graphically display the effect state on the display.Switch on and off all four major effects dynamically.Switch presets either on footswitch, app or Spark to update display.Supports the most common DIY display types: SSD1306 and SH1106.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |